Installation
Follow these four simple steps for easy installation of your stick on magnifying lenses:
IMPORTANT: WHEN INSTALLING ON A DIVE MASK, THE MASK MUST BE WASHED THOROUGHLY FIRST WITH DETERGENT AND HOT WATER, THEN THE HYDROTAC LENSES ARE INSTALLED LIKE A SUCTION CAP. WHEN FLEXED BETWEEN YOUR FINGERS THEY CURVE AND THE INNER CURVE (CONCAVE) IS THE SIDE THAT GOES AGAINST THE FLAT OF YOUR DIVE MASK.
IF THE HYDROTAC LENS DOESN'T "GRAB" ONTO YOUR MASK, THEN YOU NEED TO WASH YOUR MASK AGAIN WITH DETERGENT AND HOT WATER.
Please phone us if you cannot follow these instructions.
1.
Wash your hands and glasses with detergent and hot water to remove
any grease.
2. With clear warm water in the inside wells of your glasses,
press one HydroTac® Reading Lens onto the inside bottom of each lens. The centres
of the HydroTac® Lenses should be approximately 2.5 inches apart.
3. Check for proper placement by putting your glasses on and
looking through the Lens. Adjustments are easily made by sliding your HydroTac® lenses
while they are still wet.
4.
When done, press down firmly to remove excess water and gently pat dry with a tissue. Allow your HydroTac® Lenses to
dry completely before using.
Imported by Pevery Imports, 11/49 Head Street, Brighton. Vic. 3186.
Phone: 1300 306 376 or 0418 573 677
Fax: 03 9525 6125